![]() ![]() If the meter is not accurate enough for some special Occasion, it can set the upper and lower limit of the battery capacity through Programming Mode 3- via the SET button.The SET button on the meter backside can be used for setting and changing parameter.When the battery is connected to charger or high-current load for discharging, the displayed parameter will luctuate.The detected temperature value is the temperature ot the meter. The temperature unit can switch between C and F.The displayed percentage is the battery remaining capacity percentag0.The displayed voltage value is the detected voltage value 10-100V, no external power source required.The 7 battery bars an the display, from right to left, indicate the battery remaining capacity from law to high.if set delay turning off, after being powered on, the meter will automatically turn off when reach the set delay time. At the turned-off status, click the ON/OFF button, it will wake up the meter. Click the ON/OFF button can turn off the meter. ![]() Power on the meter, it will display battery capacity percentage.Cannect the red wire to battery positive, the black wire to battery negative, make sure the contact is firm.Connect the attached 1.25 terminal wire to the plug on the praduct backside. ![]()
0 Comments
Leave a Reply. |